Instructions for the Bow Pins:
Cut off a section of duc_ tape that is 20" or longer. Fold the tape
onto itself so the final piece is the same length, just 1/2 the width
and non-sticky on both sides. Using scissors, cut the width of this
strip in half length wise. (Keep it long, just thinner) Measure the neck
of the person who will wear the Choker. Add 1/2" for overlap on the
back. Cut the strip to this new length. Add 1/2" pieces of velcro to the
ends of the strip making sure to place one part on the outside of the
duc_ tape strip and the other piece of velcro on the under side of the
duc_ tape strip. The circular neck section is complete. You are now
ready to make the bow.
Cut off a section of duc_ tape that is 5" or longer. Fold the tape
onto itself so the final piece is the same length, just 1/2 the width
and non-sticky on both sides. Using scissors, cut the width of the strip
in half length wise. (Keep the length, only thinner) Trim this strip to
a final length of 3". Lay the strip flat so that it is wide. Take both
outside ends and fold them towards the center overlapping by 1/4". Glue
at the center. First the bottom to middle and then the middle to top
layer.
Cut off a section of duc_ tape that is 2" or longer.
Using scissors, cut the piece to 1/2" by 1". Wrap the center of
the previously made bow to create a center section that is 1/2" in width
and ends in the back. Your bow is now complete. Attach the bow to the
center of the choker with glue. (Hot glue gun set to low temp with adult
supervision)